Skip to main content

Adtran TA900 Troubleshooting Commands

Modified on Thu, Jan 26, 2017 at 4:38 PM

Adtran TA900 Troubleshooting Commands

Posted: 13th August 2009 by Mark in SIP

My buddy at work put together a very nice list of common Adtran commands used for troubleshooting SIP trunks. We use them quite often.

Debug Output

COMMAND	DESCRIPTION
show debugging	shows current enabled debug commands
debug sip stack messages	shows sip debug information
debug isdn l2-formatted	shows isdn debug information (easier use)
debug voice verbose	shows all voice messaging
debug isdn verbose	shows all isdn messaging
debug interface T1 0/4 rbs	shows robbed bit signaling from CAS circuit
undebug all	turns off all debugging

Utility Commands

COMMAND	DESCRIPTION
clear count media	counters on media-gateway reset
clear counters	clears counters on interfaces
no events	turns off messages to the current session
ping	ping an IP address
traceroute	trace the router path to a destination IP address
wall	sends a broadcast message to all current users
sip trunk-registration force-register	forces sip re-registration

Show Commands

COMMAND	DESCRIPTION
show sip trunk-registration	shows registration status
show media-gateway summary	shows media gateway channel status
show media-gateway channel 0/2.1	shows media gateway channel details
show qos map	shows qos map
show flash	lists contents of the flash
show run voice [verbose]	lists running configuration for voice provisioning
show hosts	shows the hosts table with timers
show event-history	shows events and terminal commands typed
show interfaces	shows interface details
show system	shows uptime, firmware version and timing
show thresholds	shows thresholds of T1 interfaces
show users	shows current users
show voice quality-stats	shows call information including lost packets
show voice quality-stats active	shows call information including lost
show voice quality-stats active realtime	shows call information including lost
show ip traffic	TCP and UDP statistics