YEALINK W52P DECT - MANUAL RECONFIGURATION PROCEDURE - UPDATED

This document provides a procedure for flashing a Yealink W52P DECT Phone to make it ready for use with the BroadCloud service.

SPECIAL NOTE - We have tested and certified the 25.73.193.40 firmware, however this firmware version is not available on the Yealink’s website. Any download that comes from Yealink’s support page will be overwritten with the file specified in the config.

https://yealink.sipflash.com

Manual Firmware Download Instructions:

If your phone is unable to establish a connection to BroadCloud, you may need a firmware update before attempting to contact the BroadCloud configuration servers.

Confirm your phone's firmware via the Status menu on the handset: OK, Status, Base If the firmware is earlier than 25.73.193.40 , you will need to perform a manual firmware download and upgrade

1. Visit support.yealink.com to download the latest general release firmware from the manufacturer. Save the downloaded file to your desktop.
2. Using your browser, log into the phone using the default (case-sensitive) username (admin) and password (admin).
3. Under the Phone tab, select Upgrade on the left sidebar, and beneath the Select and Upgrade Base Firmware, select Browse.
4. Locate the folder where the downloaded firmware can be found. Select the firmware file.
5. Click Upgrade, and your file transfer should begin.

Once upgraded, you can confirm the new firmware via the Status menu: OK, Status,Base.

Return to the Configuring the Device section of this document to complete the BroadCloud configuration.</p>